Interface Settings - D-Link xStack Reference Manual

xStack® DGS-3120 Series Layer 2 Stackable Managed Switch Web UI Reference Guide
Click the Apply button to accept the changes made.

Interface Settings

Users can display the Switch's current IP interface settings.
To view the following window, click Management > IP Interface > Interface Settings, as show below:
The fields that can be configured are described below:
Parameter
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the IPv4 Edit button to edit the IPv4 settings for the specific entry.
Click the Add button to add a new entry based on the information entered. (EI Mode Only)
Click the Delete All button to remove all the entries listed. (EI Mode Only)
Click the IPv6 Edit button to edit the IPv6 settings for the specific entry. (EI Mode Only)
Click the Delete button to remove the specific entry. (EI Mode Only)
NOTE: To create IPv6 interfaces, the user has to create an IPv4 interface then edit it to IPv6.
Click the Add button to see the following window.
subnet should be sent. This is usually the address of a router or a host acting as an IP
gateway. If your network is not part of an intranet, or you do not want the Switch to be
accessible outside your local network, you can leave this field unchanged.
Figure 3-8 Interface Settings window (SI Mode Only)
Figure 3-9 Interface Settings window (EI Mode Only)
Description
Enter the name of the IP interface to search for.
32