D-Link xStack Reference Manual page 114

xStack® DGS-3120 Series Layer 2 Stackable Managed Switch Web UI Reference Guide
Max Response Time
Robustness Value
Last Listener Query
Interval
Data Driven Group
Expiry Time
Querier State
Fast Done
State
Report Suppression
Data Driven Learning
State
Data Driven Learning
Aged Out
Version
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
After clicking the Modify Router Port
The maximum time in seconds to wait for reports from listeners. The default setting is
10 seconds.
Provides fine-tuning to allow for expected packet loss on a subnet. The value of the
robustness variable is used in calculating the following MLD message intervals:
Group listener interval - Amount of time that must pass before a multicast router
decides there are no more listeners of a group on a network.
Other Querier present interval - Amount of time that must pass before a multicast
router decides that there is no longer another multicast router that is the Querier.
Last listener query count - Number of group-specific queries sent before the router
assumes there are no local listeners of a group. The default number is the value of the
robustness variable.
By default, the robustness variable is set to 2. You might want to increase this value if
you expect a subnet to be loosely.
The maximum amount of time between group-specific query messages, including
those sent in response to done-group messages. You might lower this interval to
reduce the amount of time it takes a router to detect the loss of the last listener of a
group.
Here the user can enter the data driven group expiry time value.
This allows the switch to be specified as an MLD Querier (sends MLD query packets)
or a Non-Querier (does not send MLD query packets). Set to enable or disable.
Here the user can enable or disable the fast done feature.
Used to enable or disable MLD snooping for the specified VLAN. This field is Disabled
by default.
Here the user can enable or disable the report suppression features.
Enable or disable data driven learning of MLD snooping groups.
Enable or disable the age out function for data driven entries.
Specify the version of MLD packet that will be sent by this port. If a MLD packet
received by the interface has a version higher than the specified version, this packet
will be dropped.
link, the following page will appear:
105