Dhcp Relay Interface Settings; Dhcp Relay Option 60 Server Settings - D-Link xStack Reference Manual

xStack® DGS-3120 Series Layer 2 Stackable Managed Switch Web UI Reference Guide

DHCP Relay Interface Settings

Users can set up a server, by IP address, for relaying DHCP information to the Switch. The user may enter a
previously configured IP interface on the Switch that will be connected directly to the DHCP server using this window.
Properly configured settings will be displayed in the DHCP Relay Interface Table at the bottom of the window, once the
user clicks the Apply button. The user may add up to four server IPs per IP interface on the Switch. Entries may be
deleted by clicking the corresponding Delete button.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Interface Settings as shown
below:
The fields that can be configured are described below:
Parameter
Interface Name
Server IP
Click the Apply button to accept the changes made.

DHCP Relay Option 60 Server Settings

On this page the user can configure the DHCP relay option 60 server parameters.
To view this window, click Network Application > DHCP > DHCP Relay > DHCP Relay Option 60 Server Settings
as shown below:
The fields that can be configured are described below:
Parameter
Relay IP Address
Mode
Click the Add button to add a new entry based on the information entered.
Click the Apply button to accept the changes made.
Figure 9-4 DHCP Relay Interface Settings window
Description
The IP interface on the Switch that will be connected directly to the Server.
Enter the IP address of the DHCP server. Up to four server IPs can be configured per IP
Interface.
Figure 9-5 DHCP Relay Option 60 Server Settings window
Description
Enter the DHCP Relay Option 60 Server Relay IP Address.
Use the drop-down menu to select the DHCP Relay Option 60 Server mode.
272