Table of Contents
Advertisement
8. If you have other options to install, install them now. Otherwise, continue with
Working with hard disk drives
Your server supports two 26-mm (1-in.), slim, 3.5-inch hot-swappable hard disk drives.
If a ServeRAID adapter in a RAID 1 configuration and a hot-swap SCSI backplane are
installed in your server, you can hot-swap hard disk drives without interrupting
processing and without data loss.
Note: See the User's Reference and the ServeRAID documentation on the IBM
Hard disk drive considerations
Before you install a hard disk drive, review the following:
•
•
•
•
•
Installing a hard disk drive
Some models of the xSeries 330 come with empty drive bays and a SCSI backplane.
The xSeries 330 Type 8675 supports hot-swap SCSI hard disk drives.
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 3.
Notes:
1. A hard disk drive is replaced in the same manner as a new hard disk drive is
2. If your server has a ServeRAID adapter and a SCSI backplane installed, and if
Complete the following steps to install or replace a hot-swap SCSI hard disk drive:
1. Review the safety precautions beginning on page v.
2. Remove the filler panel from one of the hard disk drive bays.
"Installing the cover" on page 15.
xSeries 330 Type 8675 Documentation CD for information on ServeRAID
adapters and hot-swapping hard disk drives.
Inspect the drive tray for any signs of damage.
Ensure that the drive is installed properly in the tray.
To maintain proper system cooling, do not operate the server for more than 2
minutes without either a drive or a filler panel installed in each bay.
If your server has a ServeRAID adapter installed, see the documentation provided
with the ServeRAID adapter for information about adding a drive.
You can hot-swap a hard disk drive without interrupting processing and without
data loss only if the hot-swap SCSI backplane and a ServeRAID adapter that is
configured as RAID 1 are installed in your system. If you use any other
ServeRAID or SCSI configuration, you cannot hot-swap a hard disk drive; you
must turn the server off and unplug the power cord before installing or replacing a
drive.
Note: For detailed instructions on how to install and replace a hot-swap drive,
see the documentation provided with the ServeRAID adapter and the
User's Reference on the IBM xSeries 330 Type 8675 Documentation CD.
installed, but you must remove the old hard disk drive first.
the ServeRAID adapter is configured as RAID 1, you can hot-swap SCSI drives.
Otherwise, you must turn the server off and unplug the power cord before
installing or replacing a drive. For more information about hot-swapping drives,
see the documentation provided with the ServeRAID adapter and the User's
Reference on the IBM Documentation CD.
Chapter 2. Installing options
11
Advertisement
Table of Contents
