Electric Motor Installation - Hangar 9 Ultra Stick 10cc Instruction Manual

148. Mount the switch for the ignition module on the side
of the fuselage. Secure the lead from the switch to the
ignition module using the fastener included with the
engine.
 ELECTRIC MOTOR INSTALLATION
149. Place the mounting template on the fuselage. Use a
5/32-inch (2mm) drill bit to drill the mounting holes
necessary to mount your particular motor choice.
150. Use a drill and 3/16-inch (5mm) drill bit to enlarge the
holes to mount the electric motor.
151. Use a #2 Phillips screwdriver to attach the X-mount to
the rear of the motor. Apply a drop of threadlock on the
screws before securing the X-mount to the motor.
152. Remove the hatch from the fuselage by lifting it at the
rear, then sliding it out of the fuselage.
™
Ultra Stick 10cc
148.
149.
150.
151.
152.
153. Trim the covering inside the opening at the rear of the
hatch. The opening is used to remove the hatch to
access the motor batteries and to allow cooling air into
the fuselage.
154. There is also an opening in the bottom of the fuselage
that can be opened to increase the air fl ow to the speed
control and batteries.
155. Use a drill and 1/4-inch (6mm) drill bit to aid in creating
a slot in the fi rewall for the motor wires. Keep the slot
toward the bottom of the fuselage so the wires will enter
underneath the tray in the fuselage. The location will vary
depending on your choice of motor.
156. Use the hardware included with your motor to attach it
to the fi rewall. The motor wires will enter the fuselage
through the slot made in the previous step.
157. Secure the speed controller inside the fuselage. Make
any connections to the motor, and for the battery, before
proceeding.
27
153.
154.
155.
156.
157.
EN