Section.3B:.electric.motor.installation - Hangar 9 Twist 60 ARF Assembly Manual

Section 3B: Electric Motor Installation
Required Parts
•.Fuselage.
•.Plywood.battery.tray.(F&R)
•.2".(51mm).aluminum.motor.spacer.(4)
1
•.8-32.x.2 / ".machine.screw.(4)
.
2
•.Hook.and.loop.strap.(2)
1
•.2
/ ".(64mm).spinner.w/hardware
.
2
Required Tools and Adhesives
•.Phillips.screwdriver.
•.Hobby.knife.
•.Soldering.iron.
•.Drill
•.Drill.bit:.11/64".(4.5mm)
•.Female.Deans.connector.w/wire
•.Male.Deans.connector.(3)

.Step 1
Enlarge.the.outer.mounting.holes.in.the.X-mount.of.the.
motor.using.an.11/64".(4.5mm).drill.
•.8-32.blind.nut.(4)
•.Threadlock
•.6-minute.epoxy
•.Solder

.Step 2
Attach.the.X-mount.to.the.back.of.the.motor.using.the.
hardware.provided.with.the.motor..Remember.to.put.a.
drop.of.threadlock.on.each.of.the.screws.to.prevent.them.
from.vibrating.loose.

.Step 3
Attach.the.motor.to.the.firewall.using.the.four.2".(51mm).
aluminum.motor.spacers,.four.8-32.x.2
screw.and.four.8-32.blind.nuts..Use.the.holes.that.are.
closer.to.the.opening.in.the.firewall.when.attaching.the.
motor..Use.threadlock.on.the.screws.here.as.well.
1
/ ".machine.
.
2
17