Aileron Servo Installation(Aileron Only) Or Flap Servo Installation (Quad Flap Version) - Hangar 9 Ultra Stick 40 ARF Assembly Manual


Step 8
Trim the wire 3/8-inch (9.5mm) above the bend. Use a
pushrod keeper to secure the pushrod wire to the rudder
servo horn.
22

Step 9
Repeat Steps 2 through 8 to connect the elevator pushrod
wire. When preparing the servo horn, use a hole that is 1/2-
inch (13mm) from the center of the servo horn.
Aileron Servo installation
(Aileron only) or
Flap Servo installation
(Quad Flap Version)
Required Parts
Wing assembly Control horn (2)
Servo with hardware (2) Pushrod keeper (2)
Control horn backplate (2) Clevis (2)
2-56 x 3/8 machine screw (4) Clevis retainer (2)
Pushrod wire, 6-inch (152mm) (2)
Tools and Adhesives
Pin vise Pliers
Diagonal cutters Felt-tipped pen
Hobby knife with #11 blade Thin CA
String Weight
Phillips screwdriver: #1
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
note: This section is for both the installation of the
aileron servo (aileron only) and for the flap servo (quad
flap) version of your model. The aileron servo for the
quad flap version will be installed in the next section of
the manual.

Step 1
Use a hobby knife and #11 blade to remove the covering for
the inboard servo in the bottom of the wing.
Hangar 9 Ultra Stick 40 ARF Assembly Manual