Replacing I/O Panel Gasket - Silicon Graphics 330 User Manual

Replacing I/O Panel Gasket

007-4278-001
2. The system should still be resting on its right side to facilitate the installation.
3. Place the system board into the chassis so as to align the I/O ports with their
respective holes in the I/O gasket.
4. Position the system board so as to have the standoff hooks inserted into their
corresponding holes in the system board. See Figure 2-24 for an illustration of the
procedure.
5. Secure the system board screw onto the retaining bracket. See Figure 2-21 on
page 43 for the location of the system board screw.
6. Replace the side panel as shown in "Post-installation Instructions" on page 52.
The following instructions describe how to remove the I/O panel gasket. To avoid
scratching and other possible cosmetic problems and to ease in disassembly, the system
should still be resting on its side on a padded surface.
1. Remove the system board as described in "Replacing the System Board" on page 42.
2. Locate the three notched fingers at the bottom of the I/O panel gasket, as shown in
Figure 2-25.
3. To remove the I/O panel gasket, lift one notched finger at a time out of its slot.
4. Once all three notched fingers have been lifted out of their slots, the I/O panel
gasket slides out of its housing and can be removed from the chassis.
Replacing I/O Panel Gasket
45