Silicon Graphics 330 User Manual page 2

CONTRIBUTORS
Written by Laraine MacKenzie, Cullen P. Vane, and Olivier Clarinval.
Edited by Connie Boltz.
Production editing by Karen Jacobson.
Chapters 3 and 4 provided by Acer Incorporated. Chapter 5 written by Adaptec Incorporated.
Illustrated by Dan Young
Contributions by Cullen P. Vane, Raj Mirpuri, Laura Cooper, Susan Austin, Vera Shinsky, Eileen Carter, Ellen Evlanova, Cheryl Archer, Angela
Lummel, M. Mantle, David Metzner, Patrick Heinz, Jim Pagura, Adolpho Gonzalez, Bob Sanders, Charles Alexander, Binh Dao, Paul
Davidson, Robert Andrade, D. J. Kim, Jennifer Han, Joe Hartley, J. Corchado, Tyler Vane, Zachary Vane, Craig Dunwoody, Jose Luis Serrato,
Ken Nicholson, Ujesh Desai, J. Garcia.
© 2000, Silicon Graphics, Inc. All Rights Reserved.
LIMITED AND RESTRICTED RIGHTS LEGEND
Use, duplication, or disclosure by the Government is subject to restrictions as set forth in the Rights in Data clause at FAR 52.227-14 and/or in
similar or successor clauses in the FAR, or in the DOD, DOE or NASA FAR Supplements. Unpublished rights reserved under the Copyright Laws
of the United States. Contractor/manufacturer is Silicon Graphics, Inc., 1600 Amphitheatre Pkwy., Mountain View, CA 94043-1351.
TRADEMARKS
Silicon Graphics is a registered trademark and SGI and the SGI logo are trademarks of Silicon Graphics, Inc. Acer is a registered trademark of
Acer Inc. Adaptec is a registered trademark of Adaptec, Inc. Apollo is a trademark of Avant! Corporation. Linux is a registered trademark of
Linus Torvalds. MS-DOS, Windows, and Windows NT are registered trademarks of Microsoft Corporation. Novell and NetWare are registered
trademarks of Novell, Inc. Intel, Pentium, and Xeon are is a registered trademarks or trademarks of Intel Corporation.
The contents of this document may not be copied or duplicated in any manner, in whole or in part, without the prior written permission of Silicon
Graphics, Inc.
This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
For additional Regulatory Information, refer to the label attached to the back of the system.