Removing And Installing An M.2 Ssd Storage Card - HP ProDesk 405 G4 Small Form Factor Maintenance And Service Manual

4. Align the mounting screws with the slots on the drive cage. Lower the drive into the drive cage, and then
slide it back to secure it in place.
5. Connect the power cable and data cable to the rear of the hard drive.
6. If installing a new drive, connect the opposite end of the data cable to the appropriate system board
connector.
NOTE:
blue SATA connector on the system board labeled SATA0. If it is a secondary drive, connect the other end of
the data cable to one of the light blue SATA connectors on the system board.
7. Reassemble the computer.

Removing and installing an M.2 SSD storage card

NOTE: There are two M.2 SSD sockets on the system board. The computer supports 2230 and 2280 M.2 SSD
cards.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Remove the drive cage
38 Chapter 4 Removal and replacement procedures
If the 3.5 inch hard drive is the primary drive, connect the other end of the data cable to the dark
(Access panel on page
(Front bezel on page
(Drive cage on page
(Preparation for disassembly on page
18).
19).
22).
17).