Table of Contents
Advertisement
Removing or installing an expansion card
The computer has three PCI Express x1 expansion sockets and one PCI Express x16 expansion socket.
NOTE:
You can install a PCI Express x1, x8, or x16 expansion card in the PCI Express x16 socket.
For dual graphics card configurations, the first (primary) card must be installed in the PCI Express x16 socket.
To remove, replace, or add an expansion card:
1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
3.
Turn off the computer properly through the operating system, then turn off any external devices.
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to
the internal components of the computer.
5.
Remove the computer access panel. See
6.
Release the slot cover retention latch that secures the slot covers by lifting the tab on the latch and
rotating the latch to the open position.
7.
Locate the correct vacant expansion socket on the system board and the corresponding expansion slot
on the back of the computer chassis.
8.
Before installing an expansion card, remove the expansion slot cover or the existing expansion card.
NOTE:
the expansion card.
a.
If you are installing an expansion card in a vacant socket, you must slide one of the expansion slot
covers up and out of the chassis or use a flat-bladed screwdriver to pry out one of the metal
shields on the rear panel that covers the expansion slot. Be sure to remove the appropriate shield
for the expansion card you are installing.
Regardless of the power-on state, voltage is always present on the system board as long as
Before removing an installed expansion card, disconnect any cables that may be attached to
Removing the computer access panel on page
Removing or installing an expansion card
7.
15
Advertisement
Table of Contents
