Removing And Installing A Tape Drive - Gateway E-9525R User Manual

www.gateway.com

Removing and installing a tape drive

The tape drive is not hot-swappable.
Before installing or removing the drive,
make sure that power is turned off and
the power cord(s) is unplugged.
Align the optical drive with the two clips on the left side of the optical drive
11
tray, then press the optical drive into place in the tray.
Insert the optical drive tray into the bay in the media cage until it clicks
12
into place.
Insert the media cage into the assembly bay in the chassis.
13
Secure the assembly by tightening the thumbscrew you previously
14
loosened.
Attach the 44-pin optical drive cable to the back of the optical drive
15
interface board.
Reinstall the large fan cage by following the instructions in
16
system fans" on page
Follow the instructions in
17
Reinstall the bezel, if required, by snapping it into place on the front of
18
the chassis.
Reconnect all power cords and peripheral device cables, then turn on the
19
server.
To remove and install a tape drive:
Follow the instructions in
Caution 1
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
2
Follow the instructions in
3
Remove the large fan cage by following the instructions in
4
system fans" on page
Disconnect the data and power cables from the tape drive.
5
Loosen the thumbscrew (1) holding the media cage in the chassis, then
6
push the assembly (2) out the front of the chassis.
46.
"Closing the server case" on page
"Preventing static electricity discharge" on
"Opening the server case" on page
46.
Installing and removing drives
"Replacing
32.
31.
"Replacing
35