Show Interfaces Counters - Cisco Catalyst 3750-X Command Reference Manual

show interfaces counters

show interfaces counters
Use the show interfaces counters privileged EXEC command to display various counters for the switch
or for a specific interface.
Syntax Description interface-id
errors
etherchannel
module switch- number (Optional) Display counters for the specified stack member. The range is
protocol status
trunk
Though visible in the command-line help string, the vlan vlan-id keyword is not supported.
Note
Command Modes
Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines If you do not enter any keywords, all counters for all interfaces are included.
Examples
This is an example of partial output from the show interfaces counters command. It displays all
counters for the switch.
Switch# show interfaces counters
Port
Gi1/0/1
Gi1/0/2
<output truncated>
Catalyst 3750-X and 3560-X Switch Command Reference
2-658
show interfaces [interface-id | vlan vlan-id] counters [errors | etherchannel | module switch-
number | protocol status | trunk]
(Optional) ID of the physical interface, including type, stack member
(stacking-capable switches only) module, and port number.
(Optional) Display error counters.
(Optional) Display EtherChannel counters, including octets, broadcast
packets, multicast packets, and unicast packets received and sent.
from 1 to 9, depending upon the switch numbers in the stack.
This keyword is available only on stacking-capable switches.
Note
(Optional) Display status of protocols enabled on interfaces.
(Optional) Display trunk counters.
Modification
This command was introduced.
InOctets
0
0
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
In this command, the module keyword refers to the stack member
number (1 to 9). The module number that is part of the interface ID
is always zero.
InUcastPkts InMcastPkts
0
0
InBcastPkts
0 0
0 0
OL-29704-01