Debug Platform Qos-Acl-Tcam - Cisco Catalyst 3750-X Command Reference Manual

Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands

debug platform qos-acl-tcam

Use the debug platform qos-acl-tcam privileged EXEC command to enable debugging of the quality
of service (QoS) and access control list (ACL) hardware memory manager software. Use the no form of
this command to disable debugging.
Syntax Description all
ctcam
errors
labels
mask
rpc
tcam
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
The undebug platform qos-acl-tcam command is the same as the no debug platform qos-acl-tcam
command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
OL-29704-01
debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
no debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
Display all QoS and ACL ternary content addressable memory (QATM) manager
debug messages.
Display Cisco TCAM (CTCAM) related-events debug messages.
Display QATM error-related-events debug messages.
Display QATM label-related-events debug messages.
Display QATM mask-related-events debug messages.
Display QATM remote procedure call (RPC) related-events debug messages.
Display QATM hardware-memory-related events debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Catalyst 3750-X and 3560-X Switch Command Reference
debug platform qos-acl-tcam
B-71