Show Interfaces Rep - Cisco Catalyst 3750-X Command Reference Manual

show interfaces rep

show interfaces rep
To display Resilient Ethernet Protocol (REP) configuration and status for a specified interface or for all
interfaces, use the show interfaces rep user EXEC command.
Syntax Description interface-id
detail
Command Modes
User EXEC
Command History Release
15.0(2)SE
Usage Guidelines
In the output for the show interface rep [detail] command, in addition to an Open, Fail, or AP (alternate
port) state, the Port Role might show as Fail Logical Open (FailLogOpen) or Fail No Ext Neighbor
(FailNoNbr). These states indicate that the port is physically up, but REP is not configured on the
neighboring port. In this case, one port goes into a forwarding state for the data path to help maintain
connectivity during configuration. The Port Role for this port shows as Fail Logical Open; the port
forwards all data traffic on all VLANs. The other failed Port Role shows as Fail No Ext Neighbor; this
port blocks traffic for all VLANs.
When the external neighbors for the failed ports are configured, the failed ports go through the alternate
port state transitions and eventually go to an Open state or remain as the alternate port, based on the
alternate port election operation.
Examples This is sample output from the show interface rep command:
Switch # show interface rep
Interface
---------------------- ------ ------------ ----------- ----
GigabitEthernet1/0/1
GigabitEthernet1/0/2
FastEthernet1/0/4
This is sample output from the show interface rep command when external neighbors are not
configured:
Switch # show interface rep
Interface
---------------------- ------ ------------ ----------- ----
GigabitEthernet1/0/1
GigabitEthernet1/0/2
This is sample output from the show interface rep detail command for a specified interface:
Switch # show interface gigabitethernet0/2 rep detail
Catalyst 3750-X and 3560-X Switch Command Reference
2-660
show interfaces [interface-id] rep [detail]
(Optional) Displays REP configuration and status for a specified physical interface
or port channel ID.
(Optional) Displays detailed REP configuration and status information.
Modification
This command was introduced.
Seg-id
Seg-id
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Type LinkOp
1 Primary Edge TWO_WAY
1 Edge TWO_WAY
2 INIT_DOWN
Type LinkOp
1 NO_NEIGHBOR FailNoNbr
2 NO_NEIGHBOR FailLogOpen
Role
Open
Open
Fail
Role
OL-29704-01