Debug Port-Security - Cisco Catalyst 3750-X Command Reference Manual

debug port-security

debug port-security
Use the debug port-security privileged EXEC command to enable debugging of the allocation and
states of the port security subsystem. Use the no form of this command to disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The undebug port-security command is the same as the no debug port-security command.
When you enable debugging on a switch stack, it is enabled only on the stack master. To enable
debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands Command
show debugging
show port-security
Catalyst 3750-X and 3560-X Switch Command Reference
B-86
debug port-security
no debug port-security
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Displays port-security settings for an interface or for the switch.
Appendix B Catalyst 3750-X and 3560-X Switch Debug Commands
OL-29704-01