Show Etherchannel - Cisco Catalyst 3750-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

show etherchannel

Use the show etherchannel user EXEC command to display EtherChannel information for a channel.
Syntax Description channel-group-number
detail
load-balance
port
port-channel
protocol
summary
Command Modes
User EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
If you do not specify a channel-group, all channel groups are displayed.
In the output, the Passive port list field is displayed only for Layer 3 port channels. This field means that
the physical port, which is still not up, is configured to be in the channel group (and indirectly is in the
only port channel in the channel group).
Layer 3 port channels are not supported when the switch is running the LAN base feature set.
Note
OL-29704-01
show etherchannel [channel-group-number {detail | port | port-channel | protocol | summary}]
{detail | load-balance | port | port-channel | protocol | summary}
(Optional) Number of the channel group. The range is 1 to 48.
Display detailed EtherChannel information.
Display the load-balance or frame-distribution scheme among ports in the
port channel.
Display EtherChannel port information.
Display port-channel information.
Display the protocol that is being used in the EtherChannel.
Display a one-line summary per channel-group.
Modification
This command was introduced.
Catalyst 3750-X and 3560-X Switch Command Reference
show etherchannel
2-637