Diagnostic Start - Cisco Catalyst 3750-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

diagnostic start

Use the diagnostic start privileged EXEC command to run an online diagnostic test.
Syntax Description
switch number
test
name
test-id
test-id-range
all
basic
non-disruptive
Defaults This command has no default setting.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines The switch supports these tests:
ID
---
1
2
3
4
5
6
7
---
OL-29704-01
diagnostic start switch number test {name | test-id | test-id-range | all | basic | non-disruptive}
Specify the switch number, which is the stack member number. If the
switch is a standalone switch, the switch number is 1. If the switch is in a
stack, the range is 1 to 9, depending on the switch member numbers in the
stack.
This keyword is supported only on on stacking-capable switches.
Specify the tests to run.
Specify the name of a test. For more information, see the "Usage
Guidelines" section.
Specify the ID number of a test. The range is from 1 to 7. For more
information, see the "Usage Guidelines" section.
Specify more than one test with the range of test ID numbers. For more
information, see the "Usage Guidelines" section.
Specify all the diagnostic tests.
Specify the basic on-demand diagnostic tests.
Specify the nondisruptive health-monitoring tests.
Modification
This command was introduced.
Test Name [On-Demand Test Attributes]
-------------------------------------------
TestPortAsicStackPortLoopback
TestPortAsicLoopback
TestPortAsicCam
TestPortAsicRingLoopback
TestMicRingLoopback
TestPortAsicMem
TestInlinePwrCtlr
-------------------------------------------
[B*N****]
[B*D*R**]
[B*D*R**]
[B*D*R**]
[B*D*R**]
[B*D*R**]
[B*D*R**]
Catalyst 3750-X and 3560-X Switch Command Reference
diagnostic start
2-169