Cisco Catalyst 3750-X Command Reference Manual page 819

Cisco ios release 15.2(1)e and later

Hide thumbs Also See for Catalyst 3750-X:

Table of Contents

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

AdminPowerMax

AdminConsumption

1. The configured power is the power that you manually specify or that the switch specifies by using CDP power negotiation or

the IEEE classification, which is different than the real-time power that is monitored with the power sensing feature. The

configured power values on a Catalyst 3750-E or 3560-E switch is the same as the actual power values on a Catalyst 3750 or

3560 switch.

This is an example of output from the show power inline consumption command on all PoE switch

Switch> show power inline consumption

---------- -----------

This is an example of output from the show power inline police command on a Catalyst 3750-X switch.

Switch> show power inline police

Interface State

--------- ------ ----------- ---------- ---------- ------ ------

show power inline Field Descriptions (continued)

The maximum amount of power that is allocated to the powered device in watts.

This value is the same as the value in the Cutoff Power field in the show power

inline police command output.

The device type detected: n/a, unknown, Cisco powered-device, IEEE

powered-device, or the name from CDP.

The IEEE classification: n/a or a value from 0 to 4.

The maximum amount of power allocated to the powered device in watts.

The maximum amount power allocated to the powered device in watts when the

switch polices the real-time power consumption. This value is the same as the

Max field value.

The power consumption of the powered device in watts when the switch polices

the real-time power consumption. If policing is disabled, this value is the same

as the AdminPowerMax field value.

Consumption (Watts)

-------------------

describes the output fields.

errdisable n/a

Catalyst 3750-X and 3560-X Switch Command Reference

show power inline

Catalyst 3560-x