Show Mac Access-Group - Cisco Catalyst 3750-X Command Reference Manual

show mac access-group

show mac access-group
Use the show mac access-group user EXEC command to display the MAC access control lists (ACLs)
configured for an interface or a switch.
Syntax Description interface interface-id
Command Modes User EXEC
Command History Release
12.2(53)SE2
Examples
This is a sample output from the show mac-access group user EXEC command. In this display, port 2
has the MAC access list macl_e1 applied; no MAC ACLs are applied to other interfaces.
Switch> show mac access-group
Interface GigabitEthernet1/0/1:
Inbound access-list is not set
Interface GigabitEthernet1/0/2:
Inbound access-list is macl_e1
Interface GigabitEthernet1/0/3:
Inbound access-list is not set
Interface GigabitEthernet1/0/4:
Inbound access-list is not set
<output truncated>
This is a sample output from the show mac access-group interface gigabitethernet1/0/1 command:
Switch# show mac access-group interface gigabitethernet1/0/1
Interface GigabitEthernet1/0/1:
Inbound access-list is macl_e1
Related Commands Command
mac access-group
Catalyst 3750-X and 3560-X Switch Command Reference
2-724
show mac access-group [interface interface-id]
(Optional) Display the MAC ACLs configured on a specific interface. Valid
interfaces are physical ports and port channels; the port-channel range is 1
to 48 (available only in privileged EXEC mode).
Modification
This command was introduced.
Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
Description
Applies a MAC access group to an interface.
OL-29704-01