Test Cable-Diagnostics Tdr - Cisco Catalyst 3750-X Command Reference Manual

Chapter 2 Catalyst 3750-X and 3560-X Switch Cisco IOS Commands

test cable-diagnostics tdr

Use the test cable-diagnostics tdr privileged EXEC command on the switch stack or on a standalone
switch to run the Time Domain Reflector (TDR) feature on an interface.
Syntax Description interface-id
Defaults
There is no default.
Command Modes Privileged EXEC
Command History Release
12.2(53)SE2
Usage Guidelines
TDR is supported only on 10/100/100 copper Ethernet ports. It is not supported on 10-Gigabit Ethernet
ports or small form-factor pluggable (SFP) module ports. For more information about TDR, see the
software configuration guide for this release.
After you run TDR by using the test cable-diagnostics tdr interface interface-id command, use the
show cable-diagnostics tdr interface interface-id privileged EXEC command to display the results.
Examples
This example shows how to run TDR on an interface:
Switch# test cable-diagnostics tdr interface gigabitethernet1/0/2
TDR test started on interface Gi1/0/2
A TDR test can take a few seconds to run on an interface
Use 'show cable-diagnostics tdr' to read the TDR results.
If you enter the test cable-diagnostics tdr interface interface-id command on an interface that has a
link status of up and a speed of 10 or 100 Mb/s, these messages appear:
Switch# test cable-diagnostics tdr interface gigabitethernet1/0/3
TDR test on Gi1/0/9 will affect link state and traffic
TDR test started on interface Gi1/0/3
A TDR test can take a few seconds to run on an interface
Use 'show cable-diagnostics tdr' to read the TDR results.
Related Commands Command
show cable-diagnostics tdr
OL-29704-01
test cable-diagnostics tdr interface interface-id
Specify the interface on which to run TDR.
Modification
This command was introduced.
Description
Displays the TDR results.
Catalyst 3750-X and 3560-X Switch Command Reference
test cable-diagnostics tdr
2-963