2N EasyRoute User Manual page 53

Save button
Push this button to save the new settings.
Default button
Push this button to restore the default values (factory settings).
Routing
Prefix
Enter the call type identifying prefixes (GSM, trunk, free, etc.). The Others row is
used for calls with prefixes that are not included in the table. One empty row is
always available. When a prefix is entered and saved, another empty row is
added. To remove a row, delete the prefix and save the data again.
Setting options:
Default setting:
Allow
Use this parameter to allow/bar calls with the prefixes specified on the given row.
Setting options:
Default setting:
Length
Use the Length parameter to define the expected length of a number including its
prefix for the given row. This enables the start of a GSM dialling immediately after
the last digit is dialled. If the telephone number to be dialled is shorter, the call
will not be set up until the predefined timeout elapses. '0' means that the function
is disabled.
Setting options:
Setting step:
Default setting:
#
Use the # parameter to enable call set-up whenever a '#' (hash) is received. This
character is removed from the number to be dialled. If you want a '#' to be part
of the dialled number, you cannot use this function for the given prefix.
Setting options:
Default setting:
Remove
Use the Remove parameter to enable automatic call forwarding. Define a number
of digits (prefix) to be removed from the beginning of the number to be dialled.
Setting options:
Setting step:
Default setting:
Table of Programmable Parameters
0–15 characters (0–9, *, #)
Empty
ON/OFF
ON
0-20
1
0
ON/OFF
ON
0–20
1
0
53