2N EasyRoute User Manual page 48

Save button
Push this button to save the new settings.
Default button
Push this button to restore the default values (factory settings).
SIP > Flood
Enable
Enable/disable the use of the Flood function.
Setting options:
Default setting:
Port
Set the port to which stimulation packets should be sent.
Setting options:
Setting step:
Default setting:
Packet size
Set the size of the stimulation packet.
Setting options:
Setting step:
Default setting:
Sending intervals
Set the time intervals for stimulation packet sending.
Setting options:
Setting step:
Default setting:
Tip
The Flood function has been developed to compensate the initial data
n
transmission slowness in the UMTS network. Thus, 2N
stimulation packets at preset intervals to achieve the optimum data flow
at initial stages of bulk data transmissions. The default value is Enabled.
Do not disable this function to avoid connection errors at the beginning of
n
VoIP and T.38 FAX calls.
Table of Programmable Parameters
Enable/Disable
Enable
1 - 65535
1
65534
0 – 1024 B
1
100
5 – 500 ms
1
20
ERF
®
EasyRoute sends
48