2N EasyRoute User Manual page 49

Save button
Push this button to save the new settings.
Default button
Push this button to restore the default values (factory settings).
FAX > Basic
Enable
Enable the FAX function.
Setting options:
Default setting:
Protocol
Set the protocol for FAX transmission.
Setting options:
Default setting:
Port
Set the port to be used for FAX data transmission.
Setting options:
Setting step:
Default setting:
Data flow
Set the data flow to be preferred. The data flow set in here need not necessarily
be used. If two opposite devices agree so during the FAX call set-up, a lower value
may be selected.
Setting options:
Default setting:
TCF
Define how to perform the training sequence according to the T.38 protocol.
Setting options:
Default setting:
Buffer size
Set the buffer size for UDP/TCP datagrams.
Default setting:
Table of Programmable Parameters
Enabled/Disabled
Disabled
UDP / TCP
UDP
1 - 65535
1
10004
2400 bps
4800 bps
7200 bps
9600 bps
14400 bps
9600 bps
Local
Training sequence is performed locally only.
Transferred
Whole training sequence is transmitted in the same
way and under the same conditions as the following
FAX message.
Transferred
200 B
ERF
49