2N EasyRoute User Manual page 50

Datagram size
Set the maximum UDP/TCP datagram size.
Default setting:
Error correction method
Define how to correct the errors in the FAX messages to be transmitted.
Setting options:
Default setting:
Save button
Push this button to save the new settings.
Default button
Push this button to restore the default values (factory settings).
FAX > Advanced
Reinvite tone
Define to which of the detected tones the reinvite tone should be sent in the SIP
protocol from the voice codec (G.729, e.g.) for T.38 transmission.
Setting options:
Default setting:
Reinvite direction
Define which of the subscribers should make reinvite from the voice codec for
T.38.
Setting options:
Default setting:
Enable old ASN notation
The transmission obeys the preset ASN standard.
Setting options:
Default setting:
Disable ECM
Set error correction on the T.30 level for the devices that enable this function.
Setting options:
Default setting:
Tip
Each network to which 2N
n
different way. If you have FAX transmission problems, you can probably
resolve them by setting the above mentioned parameters properly.
Table of Programmable Parameters
200 B
Redundancy
®
2N EasyRoute uses the Redundancy Error Correction.
FEC
®
2N EasyRoute uses the Forward Error Correction.
Redundancy
CNG / CED / DIS
CNG
Calling / Called
Called
Enabled / Disabled
Enabled
Enabled / Disabled
Disabled
®
EasyRoute is connected may behave in a
ERF
50