Dual Wiring of 2-Wire and 4-Wire Endpoints
Do not simultaneously wire a 2-wire and 4-wire endpoint to the same equipment location in an MDF,
even though they connect to different colored wire pairs. The system uses separate circuit packs to
interface 2- and 4-wire endpoints, and none are capable of interfacing both.
Install 26B1 Selector Console — Optional
1
Connect the supplied 3-foot (0.9 m) D8AC cable to the modular jack on the bottom of the 26B1
Selector Console.
2
Route the cable to the attendant console and connect to the DXS/BLF jack.
3
Attach labels according to the Attendant Console form.
4
Administer the console using Administrator's Guide for Avaya Communication Manager.
Administer IP Stations and Trunks
For complete information on administering IP stations and trunks, see Administrator's Guide for Avaya
Communication Manager.
Install and Wire Telephone Power Supplies
This section provides information and wiring examples of installation procedures for various telephone
and console power supplies. These are examples only and actual wiring procedures may vary at each site.
The power is provided to telephones or consoles either locally or centrally.
Centrally located power supplies include
•
1145B2 Power Supply
•
1152A1 Mid-Span Power Distribution Unit
•
P333T-PWR Power over Ethernet Stackable Switch
Local power supplies include
•
1151B1 and 1151B2 Power Supplies
Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
June 2004
on page 84
on page 93
on page 99
Installing and Cabling the Cabinets
Install and Wire Telephone Power Supplies
on page 96
81