Installation - NEC N8100- 1241F User Manual

Installation

Take the following steps to install the CPU.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Remove the logic cover and drive cover.
4.
Remove the processor duct from the chassis.
IMPORTANT:
5.
Locate the CPU socket which you are going to install CPU.
6.
Remove the protective socket cover from the load plate.
IMPORTANT:
replace the socket cover if the processor is removed from the socket.
Make sure not to damage the internal cables.
Do not discard the protective socket cover. Always
Upgrading Your Server 9-37