NEC N8100- 1241F User Manual page 268

9-28 Upgrading Your Server
10.
Install the components you removed in steps 1 to 3.
11.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed in Chapter 8.
12.
Run the BIOS SETUP utility and select [Advanced] → [Memory Configuration] to verify
that the installed DIMM shows the status "Normal". (See Chapter 4 or details.)
13.
Select "Yes" for [Reset Configuration Data] on the [Advanced] menu.
This setting is required to change the hardware configuration data. See Chapter 4 for
details.
14.
If the Windows operating system is in use, set the paging file size to the recommended
value (total memory size × 1.5) or a greater value. See Chapter 5 for details.