Installing The Rail Assemblies - NEC N8100- 1241F User Manual

Installing the Rail Assemblies

Make sure of the right side rail assembly or the left one when installing it. See the figure below.
To adjust the length of the rail according to the depth of the rack, loosen screws securing the rail
assembly.
Front
1.
Align the front and rear frames of rail assembly to the location where the core nuts are
installed.
Locate the rail assembly so that the frame of the rack is located between core nuts and
frames of rail assembly.
2.
Firmly secure the rail assembly (two screws for the front of a rail, two screws for the rear
of a rail).
Screw hole for
fixing the server to
the rack
3.
Tighten the screws according to the length of the rail.
4.
Install the rail for another side in the similar procedure.
NOTE:
as another rail assembly already installed.
Make sure that the rail assembly is installed at the same height
Front of the rack
Setting Up Your Server 3-9
Screws
Screws
Rear