Connecting Power Cord - NEC N8100- 1241F User Manual

CONNECTING POWER CORD

Connect the provided power cord to the server.
Observe the following instructions to use the server safely. Failure to follow these
instructions may result in death or serious personal injury. See pages 1-3 to 1-8
for details.
Observe the following instructions to use the server safely. Failure to follow these
instructions may cause a fire, personal injury, or property damage. See pages 1-3
to 1-8 for details.
1.
Plug the provided power cord into the power receptacle on the rear of the server.
2.
Plug the other end of the power cord into the wall outlet.
IMPORTANT:
Connect the power cord to a circuit breaker of 15A or less.
Secure the power cord with a tie wrap.
Do not hold the power plug with a wet hand.
Do not connect the ground wire to a gas pipe.
Do not plug the power cord in to an improper power source.
Do not connect the power cord to an outlet that has an illegal number of
connections.
Insert the power plug into the outlet as far as it goes.
Use the authorized power cord only.
AC inlet
Power supply
slot (option)
Setting Up Your Server 3-29
WARNING
CAUTION
Power supply
slot (standard)
AC inlet