NEC N8100- 1241F User Manual page 130

4-30 Configuring Your Server
6.
Press F10 to create logical drive.
The "Logical Drives Configure" screen appears. (The figure below shows an example of
RAID1 configured with two hard disk drives.)
7.
Select "RAID," "Size", "DWC", "RA", or "Span" by using cursor keys. Then press Enter
to fix the selection and set each value.
(1) "RAID": Sets RAID level.
Parameter
0
1
5
10
The selectable RAID level varies depending on the number of hard disk drives
that configure a pack.
(2) "Size": Sets logical drive size.
Up to 40 logical drives can be created per disk array controller.
(3) "DWC": Sets parameter for Disk Write Cache.
Parameter
Off
On
(4) "RA": Sets parameter for Read Ahead.
Parameter
Off
On
Remarks
RAID0
RAID1
RAID5 (option)
Spanning of RAID1
Remarks
Write through
Write back
Remarks
Does not perform read ahead.
Performs read ahead.