NEC N8100- 1241F User Manual page 79

2.
At least two persons are required to install the server. Securely hold the server and install
it in the rack.
Firmly fit the inner rails on the sides of the server into the rail assemblies that are installed
on the rack, and then slowly push the server into the rack.
If the server is locked on its way into the rack, slowly push it in while pressing the release
levers on the right and left sides of the server.
When the server is installed for the first time, the mechanical parts are rather hard to slide.
You may feel strong friction when pushing in the server. In this case, strongly push it in.
IMPORTANT:
levers or rails.
3.
Confirm that the sliding rails work normally by pulling the server out of the rack and
pushing it in several times.
NOTES:
To install the server in the location adjacent to the other device, pay
attention to interference. If the installing server disturbs the other
devices already been installed, adjust the position, and install the
rail assembly again.
Confirm that the sliding rails work normally. If the sliding rails are
stuck to the rack frame and do not come out, reinstall them.
Be very careful not to get your finger caught in the
Release lever
Setting Up Your Server 3-11