NEC N8100- 1241F User Manual page 82

3-14 Setting Up Your Server
4.
Loosen the two captive thumbscrews.
5.
Hold the handle and pull out the server from the rack slowly and carefully.
The server clicks to be latched.
6.
Pull out the server from the rack with the right and left release lever pressed to release the
latch.
IMPORTANT: Do not apply any load on the server pulled out from the
rack. Doing so may cause personal injury if the server drops.
7.
Firmly hold the server, and take it out from the rack.
IMPORTANT:
Pull out the server slowly holding the bottom of the server by at
least two persons.
Do not apply any load on the server pulled out from the rack. Doing
so may cause personal injury if the server drops.
Be very careful not to get your finger caught in the levers or rails.
To remove some mechanical parts of the rack, see the installation procedure.
Captive thumbscrews
Release lever