NEC N8100- 1241F User Manual page 233

[OK] does not appear on [Role of Computer] screen.
→ The [OK] does not appear if the Setup File that has already been created is loaded.
→ [OK] appears only when you first entered the [Role of Computer] screen.
Once you go to the next screen from [Role of Computer], the [OK] will not appear
even if you click [Back] to go back to the [Role of Computer] screen.
Select [Use Existing Partition] at [System Partition], but the OS is installed in the
whole area of the disk.
→ Is there any other partition than the partition to re-use (excluding maintenance area)?
If the partition other than the one to re-use does not exist, the setup will reserve the
whole area of the disk to install operating system.
Specified to join the Domain, but the system is installed as Workgroup.
→ When the setup fails to join the Domain during the installation, it will install the
system as Workgroup. Open [System] in Control Panel to specify joining the Domain.
Entered the incorrect Product ID/CD key.
→ Even if you entered the incorrect Product ID/CD key, Express Setup will start.
However, the setup will stop and asks you to re-enter the correct value. Also in this
case, input request will occur when rebooting after GUI setup completed during
Express Setup. If these 2 inputs are done correctly, there is no problem on Windows
setup.
Unable to specify the details of Network adapter.
→ In Express Setup, you can not specify the details of Network adapter. Specify them
from Control Panel after starting Windows.
Connected more than two Network adapter and specified different protocol for each
adapter, but all the protocols are specified on either adapter.
→ It's a design. Each adapter is specified so that all the installed protocols can be used.
The value that can not be specified during Express Setup will all be specified by
default value.
Troubleshooting 8-27