Removal; Use Of Internal Hard Disk Drives In A Disk Array Configuration - NEC N8100- 1241F User Manual

Removal

Remove a disk array controller board in reverse order of the installation steps.

Use of internal hard disk drives in a disk array configuration

Onboard RAID Controller (RoMB)
RAID controller is factory embedded in your mother board.
For enabling the onboard RAID controller, refer to Chapter 4 for detail.
Optional RAID Controller
Your server can include the optional PCI add-in RAID controller. The optional RAID controller can
control the internal hard disk drives as the RAID drive.
To use the internal hard disk drives in a disk array configuration with an optional RAID controller,
reconnect the hard disk drive interface cable on the mother board. At the factory, the interface cable
is connected to the mother board connector as shown below.
FRONT
SAS connector 2
(for ports 4 and 5) *1
SATA connector 1
(for channels 0 and 1)
*1 The SAS connectors are mounted only for the SAS hard disk drive model only.
*2 The SATA connectors are mounted only for the SATA hard disk drive model only.
Upgrading Your Server 9-51
SAS connector 2
(for ports 4 and 5)
*2
Mother board
*1
SAS connector 1
*1
(for ports 0 and 3)
REAR