Placing Calls When The Primary Line Is An Analog Line - Polycom SoundPoint IP 200W User Manual

When you are placing or receiving calls
over an analog line, an icon will be
displayed which indicates the status of
your call:
Call Status
Outbound Analog Call
Incoming Analog Call
Current Analog Call
Placing Calls when Primary
Line is Specified as Analog
When an analog line is specified as the
primary line, the procedure for placing
analog calls will (in most cases) be
identical to the procedure listed in
the SoundPoint IP 200W
page 16 of this User Guide.
However, if you wish to place an IP call
when your primary line is an analog line,
use the following procedure:
Placing an IP Call
• In Idle mode, dial the desired num-
ber and then press the Options soft
key, choose Call on VoIP, and then
press the OK key.
Placing Analog Calls when
Primary Line is Specified as IP
When an IP line is specified as the primary
line, you will need to use the Options soft
key and menu items to place analog calls.
Placing an Analog Call
• In Idle mode, dial the desired num-
ber, press the Options soft key, and
then choose Call on landline. Press
the OK key.
Icon Displayed
Using
, starting on
21