Placing.calls.over.an.analog.telephone.line; Specifying A Primary Line For Outbound Calls - Polycom SoundPoint IP 200W User Manual

Placing.Calls.Over.an.Analog.Telephone.Line

You may use your SoundPoint IP 200W
to place analog calls, provided that the
gateway is connected to a functioning
analog line. Connection to an analog tele-
phone line is optional, and is not required
for your SoundPoint IP 200W to function
properly.
DC 9-20V LAN
Reset
SOUNDPOINT IP 200W
GATEWAY
If your Internet Telephony Service Provider does not provide a service whereby
you can place calls to your local emergency call center with your caller ID
displayed, you will need an analog telephone line to place emergency calls.
For more information, see
User Guide.
Specifying a Primary Line
for Outbound Calls
When connected to an analog line, you can
specify a primary telephone line, which is
used for outbound calls when you press
.
To specify the primary line:
1. In the main menu, choose Settings,
and then press the OK key.
2. Choose Telephony settings, press
the OK key, and then choose
Primary line. Press the OK key.
3. Select either Landline or VoIP line,
and then press the OK key.
IP NETWORK
LAN
CONNECTION
( REQUIRED)
Line
ANALOG TELEPHONE LINE
Emergency Line Settings
If your SoundPoint IP 200W is connected
to an analog line, you may choose between
placing calls over an IP network or your
analog line (as shown below).
INTERNET
(OPTIONAL)
20
VoIP
TELEPHONE
ANALOG
TELEPHONE
on page 13 of this
PSTN/
POTS