Installing And Charging The Batteries - Polycom SoundPoint IP 200W User Manual

Installing the Batteries
1. Push in and down on the back of
the handset to release the battery
cover.
2. Insert the rechargeable AA batteries
into the handset, then slide the
battery cover shut.
Use only approved Nickel Metal Hydride (Ni-MH) rechargeable batteries. Never use
any other batteries or conventional alkaline batteries. Two standard AA size Ni-MH
rechargeable batteries of 1700 mAh 1.2V are included with this phone. Replacement
batteries are available from Polycom. For more information, contact your reseller.
POLYCOM IS NOT LIABLE FOR ANY DAMAGES CAUSED BY THE USE OF
INCORRECT BATTERIES.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT
TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Charging the Batteries
1. Connect the charging cradle adapter to the DC jack on the back of the charging
cradle, then plug the adapter into an active power outlet.
2. To charge the batteries, place the
handset in the charging cradle.
Batteries must be fully charged
before first use. Charging of
batteries may take up to 10 hours.
3