Installing A New Or Replacement Rtm Isdn Card - Polycom 2000 Hardware Manual

RealPresence®Collaboration Server (RMX) 2000 Hardware Guide

Installing a New or Replacement RTM ISDN Card

Carry out the following procedure to install a new RTM ISDN card or replace an existing one.
To install a new or replacement RTM ISDN card:
1 On the new RTM ISDN card move the ejector levers to their fully open position.Slide in the RTM
ISDN card in the RMX slot.
An RTM ISDN card must connect directly to an MPMx/MPMRx card in the opposite facing front slot.
2 Push the card into the slot until the ejector levers touch the front edge of the card cage.
3 Push the ejector levers to their fully closed position.
4 Tighten the captive screws on each side of the rear panel of the card, securing the RTM ISDN card
to the RMX.
5 Connect the RJ-45 terminated PRI cables into any of the slots labeled PRI1 - PRI12.
7 E1 or 9 T1 cables can be connected to each RTM ISDN card, up to a total of 14 E1 or 18 T1 PRI
cables when two RTM ISDN cards are installed.
Polycom, Inc. 49