Installing Or Replacing The Rtm Lan; Removing The Blank Cover (For New Installations); Removing An Existing Rtm Lan Card - Polycom 2000 Hardware Manual

RealPresence®Collaboration Server (RMX) 2000 Hardware Guide
6 Turn ON the RMX.
7 Login on to the RealPresence Collaboration Server Web Client.
When a new ISDN card is installed you are required to do the following:
a Update your licence. For more information see, RealPresence Collaboration Server
1500/1800/2000/4000 Getting Started Guide,
b In the ISDN/PSTN Network Services define a New ISDN Network Service. For more information
see, RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Administrators Guide,
Adding/Modifying ISDN/PSTN Network Services

Installing or Replacing the RTM LAN

The RTM LAN card on the rear of the RMX 2000 provides connectivity to all the MCU modules. The RTM
LAN card must be seated opposite to an MPMx/MPMRx card located in the top slots on the front of the RMX.

Removing the Blank Cover (for new installations)

For details, see Removing the Blank Cover from the Rear Panel

Removing an Existing RTM LAN Card

Use the following procedure to remove the RTM LAN card from its slot (not required when installing a new
card).
To remove an existing RTM LAN card:
1 Ensure that the power switch/circuit switch on the RMX 2000 is turned OFF (O).
2 Remove the cables connected to the card.
3 Unscrew the captive screws on the rear panel of the RMX 2000 that secure the RTM LAN card.
U
4 Carefully slide the RTM LAN card out through the rear panel.
Polycom, Inc.
Procedure 2: Product Registration
.
.
.
.
50