RealPresence®Collaboration Server (RMX) 2000 Hardware Guide
Inserting the RTM LAN (with 4 LAN ports) to its Slot
Use the following procedure to insert the RTM LAN card into its slot (not required when installing a new
card).
To install the RTM LAN card (with 4 LAN ports) into its slot:
1 On the card to be installed, move the ejector levers to their fully open position.
2 Slide in the replacement RTM LAN card.
An RTM LAN card must connect directly to an MPMx/MPMRx card in the opposite front slot.
3 Push the RTM LAN card firmly into the backplane, making sure it is properly seated in its slots.
4 Ensure that the metal ejector levers are fully retracted into their housings.
5 Tighten the captive screws on the rear panel of the RMX 2000 that secure the RTM LAN card.
6 Reconnect the cables.
7 Turn ON the RMX 2000.
Polycom, Inc.
51