Fault Codes - Xerox CopyCentre 133 User Manual

Fault Codes

When a fault occurs, the touch screen displays a message on how to clear the fault.
Some faults indicate customer maintenance, while others require the attention of the
Key Operator and/or System Administrator. The following table represents some of the
fault codes and their corresponding corrective actions. These may appear in the Print
Queue or Faults List available in the Machine Status mode.
Code
002-770
003-750
003-751
016-712
003-753
003-760
003-761
003-780
003-795
003-972
003-973
003-970
003-976
016-981
003-977
003-980
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128/133 User Guide
The job template could not be processed due to insufficient disk space. Delete
unnecessary data from the disk.
No document was saved for the double-sided Booklet Creation feature. Check
the setting of the double-sided Booklet Creation feature.
The specified document area is too small. Select a greater resolution or a larger
scan area.
The selected resolution was too large for scanning mixed size originals using
the document feeder. Select 200 dpi or lower to scan the document.
Incompatible features are selected on the [Scan Options] screen. Check the
selected options.
The paper size in the tray selected by auto tray switching, differs from the paper
size in the tray selected at the tray selection. Either change the paper size for
the tray, or change the paper type priority setting.
Compression of scanned data was unsuccessful. Lower the resolution or
reduction/enlargement ratio to reduce the data size, or send the document in
smaller segments.
The reduction/enlargement ratio exceeds the setting range when the scanned
document is enlarged/reduced to the specified paper size. Directly enter the
reduction/enlargement ratio, or change the paper size.
The number of scanned pages exceeds the impression limit set for the service.
Consult the Key Operator for the impression limit.
The direction of the set document does not match the direction of paper in the
selected tray. Start the job as it is, or cancel the job and select the correct
setting.
An error occurred because the document size exceeds the scanning area of the
machine. Change the document size or divide and send the document in
smaller segments.
The document size differs from the one set previously for the Bound Originals/
Booklet Creation/Poster feature. Set the correct size of document and restart
the job.
The staple position is not correct. Check the document orientation and staple
position, and select the correct settings or cancel the staple feature.
Description and Remedy
Fault Codes
329