Basic Tcp/Ip Settings; Installation Procedure - Xerox FaxCentre 2218 System Administration Manual
Xerox faxcentre 2218: user guide
Hide thumbs
Also See for FaxCentre 2218:
- User manual (212 pages) ,
- Voluntary product accessibility template (11 pages) ,
- Service manual (10 pages)
Table of Contents
Advertisement
Basic TCP/IP Settings
Before the printer can be used on the network, the TCP/IP addresses need to be entered.
These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) or
Bootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you need
to obtain the following:
TCP/IP Address
Gateway Address
Subnet Mask Address
Primary DNS Server Address
Installation Procedure
There are three stages required to install the WorkCentre 4118 / FaxCentre 2218 in a TCP/IP
networking environment:
Network Communication Setup
Workstation Setup
Test Print
Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide
This requires the WorkCentre 4118 / FaxCentre 2218 to be setup for TCP/IP.
This requires the workstations in the networking environment to be
configured to communicate with the WorkCentre 4118 / FaxCentre 2218.
A print job should be submitted to ensure the WorkCentre 4118 / FaxCentre
2218 has been installed and configured correctly.
Page 2-5
Advertisement
Table of Contents
