Basic Tcp/Ip Settings; Installation Procedure - Xerox WorkCentre 4118 System Administration Manual
Xerox workcentre 4118: user guide
Hide thumbs
Also See for WorkCentre 4118:
- Quick use manual (146 pages) ,
- Brochure & specs (4 pages) ,
- Quick reference manual (2 pages)
Table of Contents
Advertisement
Basic TCP/IP Settings
Before the printer can be used on the network, the TCP/IP addresses needs to be entered.
These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) or
Bootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you need
to obtain the following:
TCP/IP Address
Gateway Address
Subnet Mask Address
Primary DNS Server Address
Installation Procedure
There are three stages required to install the WorkCentre 4118 in a TCP/IP networking
environment:
Network Communication Setup
Workstation Setup
Test Print
Xerox WorkCentre 4118 System Administration Guide
This requires the WorkCentre 4118 to be setup for TCP/IP.
This requires the workstations in the networking environment to be
configured to communicate with the WorkCentre 4118.
A print job should be submitted to ensure the WorkCentre 4118 has been
installed and configured correctly.
Page 2-5
Advertisement
Table of Contents
