PLOT MODE GRAPHICS DENSITY COMMANDS
High Horizontal
Density Graphics
High Vertical
Density Graphics
Chapter 4. Printronix P Series Emulation
Prints dots at the even
numbered dot columns.
Formats
<EOT>
<SFCC> d
Decimal:
<EOT>
<SFCC> 100
Hex
:
04
<SFCC> 64
BASIC:
CHR$(<SFCC>);"d";
The even dot plot code is used for programming high density graphics
and must be used in conjunction with the Odd Dot Plot code (05
hex). Refer to the Graphics section for detailed plot mode information.
Modifies the paper motion for a
plot mode line to 1/144 inch rather than 1/72 inch. The ENQ (plot
mode code) should precede the DLE. See the discussion in the section
on dot graphics for more information. When not preceded by a plot
mode code, DLE acts as a VFU channel command.
Format
<DLE>
Decimal:
16
Hex:
10
BASIC:
CHR$(10);
Notes
GENICOM private code (not part of the target printers control codes).
or
or
or
102
GEK-00029B