Genicom GEK 00031B Programmer's Manual page 191

DECSHTS
DECSVTS
GEK-00029A
Set Horizontal Tab Stops: This sequence will set multiple horizontal
tab stops. DECSHTS allows up to 16 tab stops to be set at once. Up
to 32 horizontal tabs can be stored. If more than 32 tabs are specified
by the escape sequence, the leftmost 32 will be retained. The Pn
values can be in any order in the escape sequence. The value units
are in decipoints, pixels, or character cells depending on the selection
of PUM and SSU.
General Command Syntax
ESC [ P1 ; P2 ; ... ; P32 u
27 71 Pn1 ; Pn2 ; ... ; Pn16 u
Decimal:
1B 5B Pn1 3B ... Pn16 75
Hex:
CHR$(27);"["; Pn1 ;";"; Pn2 ;";"; ... ; Pn16 ;"u";
BASIC:
The tabs are set and sorted into the current settings. If the
current settings are 1", 2", and 3", a command to set a tab at
1.5" would now have four tab sets.
Set Vertical Tab Stops: This sequence will set multiple vertical tab
stops. DECSVTS allows up to 16 tab stops to be set at once. Up to
67 vertical tabs can be stored. The default is set to stop at every line.
The Pn values can be in any order in the escape sequence. The value
units are in decipoints, pixels, or lines depending on the selection of
PUM and SSU.
General Command Syntax
ESC [ Pn1 ; Pn2 ; ... ; Pn16 v
27 71 Pn1 ; Pn2 ; ... ; Pn16 v
Decimal:
1B 5B Pn1 3B ... Pn16 76
Hex :
CHR$(27);"["; Pn1 ;";"; Pn2 ;";"; ... ; Pn16 ;"v";
BASIC:
The tabs are set and sorted into the current settings. If the
current settings are 1", 2", and 3", a command to set a tab at
1.5" would now have four tab sets.
NOTE
NOTE
191
5000 Series Programmer's Manual