Genicom GEK 00031B Programmer's Manual page 162

SGR (n1)(n2)... m
DECRLGS
Chapter 7. Dec LG/Compaq LG Plus Emulation
Select Graphics Rendition : This sequence will select the Font (mode
and character style) by using one or more of the following parameters:
0 Normal Printing Mode (Default)
1 Bold Print Mode
4 Underline Mode
10 Default (Data Processing)
11 Correspondence
12 OCR-A
13 OCR-B
14 Data Processing
15 High speed draft
16 Data Processing
17 Correspondence
18 Data Processing
19 Near Letter Quality
21 Double Underline Mode (uses normal underline mode)
22 Cancel Bold Mode
24 Cancel Underline Mode
53 Overscore mode
55 Cancel overscore
Decimal: 155 n1 n2 ... m
Hex: 9B n1H h2H ... 6D
BASIC: CHR$(155);CHR$(n1);CHR$(n2);...;"m";
Request Logo Status : This command applies to the serial interface
only. It requests a status report of the logos available for printing.
The logo string contains a list of all the valid logos loaded in the
printer and their comment strings. Each logo number and comment
start on a new line, separated by commas.
Decimal: 155 23 112
Hex: 9B 27 70
BASIC: CHR$(155);CHR$(23);CHR$(112);
Reply: DCS &w (logo #) (string) ST
90 26 77 (logo #) (string) 9C
This command works only when the printer is connected to the
host through the serial interface.
NOTE
162
GEK-00029B