Genicom GEK 00031B Programmer's Manual page 85

Bold Print OFF
Single Line
Double High
Emphasized Print
ON
GEK-00029B
Deselects Bold Print mode.
Format
<SFCC> H
Decimal: <SFCC> 72
Hex: <SFCC> 48
BASIC: CHR$(<SFCC>);"H";
Indeterminate Conditions
This sequence resets Bold Print printing only. Other attributes
( double wide, etc) remain active.
Selects elongated (double high) character printing for one line only.
Elongated characters are approximately double height but standard
width. The elongated character control code is a line-by-line print
attribute; when the control code is received, one entire line of
elongated characters is printed and then automatically reset at the
end of the line.
Format
<SFCC> h
<BS> Selects Double High when the Double High print option is
selected from the control panel.
Decimal: <SFCC> 104 or
8
Hex : <SFCC> 68 or
08H
BASIC: CHR$(<SFCC>);"h"; or
CHR$(8);
Indeterminate Conditions
When configured for double high print from the control panel menu,
the control code BS (Hex 08) also selects elongated character printing
for a single line.
Selects Emphasized Print mode. Emphasized print, also called
"shadow" printing, consists of printing each letter twice, the second
printing horizontally offset (1/240th inch) from the first. Emphasized
print is turned off by the emphasized print reset control code or
emulation reset.
Format
<SFCC> E
Decimal: <SFCC> 69
Hex: <SFCC> 45
BASIC: CHR$(<SFCC>);"E";
Indeterminate Conditions
Emphasized print is ignored during superscript or subscript printing,
and when 15-20 cpi characters are selected.
Primary command format
85
5000 Series Programmer's Manual