Genicom GEK 00031B Programmer's Manual page 181

TBC
SM
PUM
LNM
GEK-00029A
Tab Clear: This sequence will clear horizontal or vertical tab (or tabs)
based on the parameter. If no parameter is present, the default will
be to clear the horizontal tab at the current position, if one exists.
The valid parameters are as follows:
General Command Syntax
ESC [ Ps g
Ps Tab Clear Action
0 Clear horizontal tab at current
position (Default)
1 Clear vertical tab at current position
2 or 3 Clear all horizontal tabs
4 Clear all vertical tabs
Indeterminate conditions
Other Values are reserved.
27 91 Ps 79
Decimal:
1B 5B Ps 67
Hex :
CHR$(27);"["; Ps ;"g";
BASIC:
Set Mode: This sequence will set the mode(s) indicated by one or
more parameters. Parameter values are either ANSI or Digital
private. Digital private parameters are preceded by the question mark
character.
ANSI Defined Parameter Values
Ps Mode Mnemonic
11 PUM
20 LNM
DEC Private Parameter Values
Ps Mode Mnemonic
?7 DECAWM
?29 DECPSM
?40 DECCRNLM
The meanings for these follows:
Position Unit Mode: Selects a unit of measurement used with the
escape sequences that control spacing parameters. When Position
Unit Mode is enabled, it selects either decipoints or pixels, depending
on the setting of the Select Size Unit sequence. When Position Unit
Mode is disabled, it selects a spacing unit equal to one character
position. The power-up default is PUM reset.
Linefeed New Line Mode: In the set state, LNM will cause a received
linefeed character to imply a new line, or carriage return. In the reset
state, a linefeed will provide vertical motion only, with no change in
the print position. The Default State of LNM is established by menu
selection.
Position Unit Mode
Linefeed New Line Mode
Mode Function
Autowrap Mode
Pitch Select Mode
Carriage Return/New Line
Mode
181
Mode Function
5000 Series Programmer's Manual