Genicom GEK 00031B Programmer's Manual page 194

DECVEC
Chapter 7. Dec LG/Compaq LG Plus Emulation
Drawing Vectors: This sequence draws horizontal or vertical lines
with length and width. Margins do not affect line drawing so you can
draw lines to the physical limits of the page. Use the following Pn
parameters to select the length, width, and direction of the line. An
incorrect Pn value will cancel the entire sequence.
General Command Syntax
ESC [ Pn1 ; Pn2 ; ... ; Pn5 ; ! |
P1: Define Line
0 = Draw a horizontal line to the right.
1 = Draw a vertical line down.
P2: Select the X Start Position
This parameter selects the horizontal start position on the page in
decipoints.
P3: Select the Y Start Position
This parameter selects the vertical start position on the page in
decipoints.
P4: Select the Line Length
Select the line length in the X direction for an X line. For a Y line, it
specifies the Y direction length. A 0 value defaults to 1 decipoint.
P5: Select the Line Width
Select the line width for both X and Y lines. A 0 value defaults to 1
decipoint.
27 71 Pn1 59 Pn2 59 ... 59 Pn5 59 33 96
Decimal:
1B 5B Pn1 3B Pn2 3B ... 3B Pn5 3B 21 7C
Hex :
CHR$(27);"["; Pn1 ;";"; Pn2 ;";"; ... ; Pn5 ;";";"!|";
BASIC:
194
GEK-00029B